Swap-Systems
Geplaatst: 02/09/26, 12:28
Hi Everybody,
I have a Bambu Labs A1-mini printer with an AMS lite.
Some months ago I started using the SwapSystems plate swapping mod.
It works fine, and technically I have no problems with it, but...
One always has to log in using an OTP code that they send to your email. Since the beginning there was a serious lag between sending the request for an ATP code and receiving it. On average it took between half an hour and three quarters of an hour to receive the OTP code. This breaks the work flow in such a way the I have started to go back to printing one printplate at a time. (Today I have been waiting for over one and a half hours, and still haven't received a reply. )
My question to the forum is: Does anyone have similar experiences with the swap systems mod?
Kind regards,
I have a Bambu Labs A1-mini printer with an AMS lite.
Some months ago I started using the SwapSystems plate swapping mod.
It works fine, and technically I have no problems with it, but...
One always has to log in using an OTP code that they send to your email. Since the beginning there was a serious lag between sending the request for an ATP code and receiving it. On average it took between half an hour and three quarters of an hour to receive the OTP code. This breaks the work flow in such a way the I have started to go back to printing one printplate at a time. (Today I have been waiting for over one and a half hours, and still haven't received a reply. )
My question to the forum is: Does anyone have similar experiences with the swap systems mod?
Kind regards,